How To Fix CACSDET039 - Determination of generic result type must only be used in analysis mode

SAP Error Message - Details

• Message type: E = Error

• Message class: CACSDET - Messages for Determination

• Message number: 039

• Message text: Determination of generic result type must only be used in analysis mode

What causes this issue?

The enhanced determination was started in process mode with entry point
&v1&. This entry point uses the generic result type. However the
determination process can <ZH>only</> be started in analysis mode with
the generic entry point &v1&, which is only for the purposes of
analysis.

System Response

The determination process was canceled.

How to fix this error?

If you started the determination process from a customer development,
correct your development and start the determination process again with
a valid entry point.
If the error <ZH>cannot</> be rectified, contact SAP support to have it
corrected.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CACSDET039 - Determination of generic result type must only be used in analysis mode ?

  The SAP error message CACSDET039 indicates that there is an issue with the determination of a generic result type in a context where it is not allowed. This error typically arises in the context of SAP's Customer Activity Repository (CAR) or similar applications where result types are used for analysis purposes.
  Cause:
  The error occurs when the system attempts to use a generic result type in a mode that is not intended for analysis. This can happen if:
  
  The system is in a mode that requires specific result types rather than generic ones.
  The configuration settings for the result types are not correctly set up.
  The transaction or report being executed is not designed to handle generic result types.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Mode of Operation:
  
  Ensure that you are in the correct mode that allows for the use of generic result types. If you are in a transaction or report that does not support this, switch to an analysis mode.
  
  
  
  Review Configuration:
  
  Verify the configuration settings for the result types in the relevant customizing settings. Ensure that the generic result types are properly defined and that they are intended for use in the context you are working in.
  
  
  
  Use Specific Result Types:
  
  If the analysis mode is not applicable, consider using specific result types that are allowed in the current context instead of generic ones.
  
  
  
  Consult Documentation:
  
  Refer to the SAP documentation or help resources for the specific module you are working with. This can provide insights into the expected configurations and usage of result types.
  
  
  
  Check for Updates or Notes:
  
  Look for any SAP Notes or updates that might address this issue. Sometimes, specific bugs or issues are documented by SAP, and applying a relevant note can resolve the problem.
  
  
  
  Contact SAP Support:
  
  If the issue persists after trying the above solutions, consider reaching out to SAP support for further assistance. They can provide more detailed guidance based on your specific system configuration and usage.
  
  
  
  Related Information:
  
  SAP Notes: Search for relevant SAP Notes that might address this specific error or provide additional context.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered and resolved similar issues.
  Documentation: Review the official SAP Help Portal for detailed information on result types and their configurations.
  
  By following these steps, you should be able to identify the cause of the error and implement a suitable solution.