How To Fix CACSDET016 - Force parameter has invalid determination type &1

SAP Error Message - Details

• Message type: E = Error

• Message class: CACSDET - Messages for Determination

• Message number: 016

• Message text: Force parameter has invalid determination type &1

What causes this issue?

The determination process was started with a force parameter (for the
processing mode), however this parameter has an incorrect determination
type &v1&.

System Response

The determination process was canceled.

How to fix this error?

If you started the determination process from your own development,
correct your development and start the determination process again with
a valid force parameter.
If this does not rectify the problem, contact SAP support for an
analysis and solution to the problem.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CACSDET016 - Force parameter has invalid determination type &1 ?

  The SAP error message CACSDET016, which states "Force parameter has invalid determination type &1," typically occurs in the context of SAP Convergent Charging (SAP CC) when there is an issue with the configuration of the force parameter in a charging scenario. This error indicates that the system has encountered an invalid determination type for the force parameter, which is essential for the charging process.
  Cause:
  
  Invalid Configuration: The determination type specified for the force parameter is not valid or does not exist in the system.
  Missing or Incorrect Data: The data related to the force parameter may be incomplete or incorrectly set up in the charging configuration.
  Version Mismatch: There may be a mismatch between the version of the configuration and the version of the SAP CC system being used.
  
  Solution:
  
  Check Configuration: Review the configuration settings for the force parameter in the SAP CC application. Ensure that the determination type specified is valid and correctly configured.
  Validate Determination Types: Go to the determination type settings in the SAP CC configuration and verify that the determination type referenced in the error message exists and is correctly defined.
  Correct Data Entry: If there are any missing or incorrect entries related to the force parameter, correct them to ensure that all required fields are filled out properly.
  Consult Documentation: Refer to the SAP documentation or help resources for guidance on the correct setup of force parameters and determination types.
  Testing: After making changes, test the configuration to ensure that the error no longer occurs and that the charging process works as expected.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they have found.
  Support: If the issue persists after checking the configuration and documentation, consider reaching out to SAP Support for further assistance.
  
  By following these steps, you should be able to identify and resolve the cause of the CACSDET016 error in your SAP Convergent Charging environment.