How To Fix CACSACTCMD005 - End of release rule &1 must not be after &2

CACSACTCMD005 - Overview

• Message type: E = Error

• Message class: CACSACTCMD - Actual Commission - Master Data

• Message number: 005

• Message text: End of release rule &1 must not be after &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CACSACTCMD005 - End of release rule &1 must not be after &2 ?

  The SAP error message CACSACTCMD005 indicates that there is an issue with the release rule configuration in the SAP system. Specifically, the error message states that the "End of release rule &1 must not be after &2," which means that the end date of a release rule is set to a date that is later than the start date or another related date.
  
  Cause:
  The error typically arises from one of the following scenarios:
  
  Incorrect Date Configuration: The end date of a release rule is set incorrectly, making it later than the start date or another relevant date.
  Overlapping Rules: There may be overlapping release rules that conflict with each other, causing the system to reject the configuration.
  Data Entry Error: A simple data entry mistake where the dates were entered incorrectly.
  
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Release Rule Dates:
  
  Navigate to the configuration of the release rule in question.
  Verify the start and