How To Fix C0834 - Only use characeteristics whose value is assigned autom. in the order

SAP Error Message - Details

• Message type: E = Error

• Message class: C0 - PP-PI: Messages for PI Sheet and Syntax Checker

• Message number: 834

• Message text: Only use characeteristics whose value is assigned autom. in the order

What causes this issue?

Value assignment using a characteristic value is only supported if the
characteristic value is assigned automatically in the process order.
However, the value of characteristic &V1& cannot be assigned
automatically in the process order.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Depending on your requirements, carry out one of the following steps:
Use a characteristic to which the required value is automatically
assigned in the process order.
If you cannot find a suitable characteristic, choose value assignment
using a fixed value and enter the value you need.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message C0834 - Only use characeteristics whose value is assigned autom. in the order ?

  The SAP error message C0834, which states "Only use characteristics whose value is assigned automatically in the order," typically occurs in the context of SAP's variant configuration (VC) or when dealing with configurable products. This error indicates that there is an issue with the characteristics assigned to a configurable material or order.
  Cause:
  
  
  Manual Assignment of Characteristics: The error often arises when characteristics that are not automatically assigned are being used in a sales order or production order. In variant configuration, certain characteristics should be automatically determined based on the configuration of the product.
  
  
  Configuration Profile Issues: The configuration profile for the material may not be set up correctly, leading to the system not being able to automatically assign values to certain characteristics.
  
  
  Missing Dependencies: There may be dependencies defined in the configuration that are not being met, which prevents the automatic assignment of characteristic values.
  
  
  Incorrect Order Type: The order type being used may not support the automatic assignment of the characteristics in question.
  
  
  Solution:
  
  
  Check Characteristic Assignment: Ensure that the characteristics used in the order are set up to be automatically assigned. This can be done in the configuration profile of the material.
  
  
  Review Dependencies: Check the dependencies defined for the characteristics in the configuration profile. Ensure that all necessary dependencies are correctly defined and that they are being met during the configuration process.
  
  
  Use Correct Order Type: Verify that the order type being used is appropriate for the configurable product and supports the automatic assignment of characteristics.
  
  
  Configuration Profile Settings: Review the configuration profile settings in the material master to ensure that the characteristics are correctly defined and that the automatic assignment is enabled.
  
  
  Test Configuration: Perform a test configuration of the product to see if the characteristics are being assigned correctly. This can help identify if there are any issues with the configuration logic.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on setting up variant configuration and resolving characteristic assignment issues.
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CU50 (Configuration Profile) or CS01 (Create Material BOM) to check and modify the configuration settings.
  SAP Notes: Check for any relevant SAP Notes that may address known issues or provide additional guidance on this error message.
  Training and Support: If the issue persists, consider reaching out to your SAP support team or consulting with an SAP expert who specializes in variant configuration.
  
  By following these steps, you should be able to identify and resolve the issue causing the C0834 error in SAP.