How To Fix BSP_DLC_TOOLS2066 - The config. tool for mash-ups can be started only from the embedding tool

SAP Error Message - Details

• Message type: E = Error

• Message class: BSP_DLC_TOOLS2 -

• Message number: 066

• Message text: The config. tool for mash-ups can be started only from the embedding tool

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message BSP_DLC_TOOLS2066 - The config. tool for mash-ups can be started only from the embedding tool ?

  The SAP error message BSP_DLC_TOOLS2066 indicates that the configuration tool for mash-ups can only be started from the embedding tool. This error typically arises when a user attempts to access the configuration tool for mash-ups directly, rather than through the appropriate embedding tool interface.
  Cause:
  
  Incorrect Access Method: The user is trying to launch the configuration tool for mash-ups directly, which is not allowed. The tool is designed to be accessed only through the embedding tool.
  User Permissions: The user may not have the necessary permissions to access the embedding tool or the configuration tool.
  System Configuration: There may be issues with the system configuration or setup that prevent the proper functioning of the embedding tool.
  
  Solution:
  
  Use the Embedding Tool: Ensure that you are accessing the configuration tool through the correct embedding tool. This typically involves navigating through the appropriate SAP interface or application that supports mash-ups.
  Check User Permissions: Verify that the user has the necessary permissions to access both the embedding tool and the configuration tool. If not, contact your SAP administrator to adjust the permissions.
  Consult Documentation: Refer to the SAP documentation or help resources for guidance on how to properly access and use the embedding tool and configuration tool for mash-ups.
  System Configuration Review: If the issue persists, it may be necessary to review the system configuration or consult with your SAP Basis team to ensure that all components are correctly set up and functioning.
  
  Related Information:
  
  SAP Notes and Knowledge Base Articles: Check for any relevant SAP Notes or KBA (Knowledge Base Articles) that may address this specific error or provide additional troubleshooting steps.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they have found.
  SAP Support: If the problem cannot be resolved through the above steps, consider reaching out to SAP Support for further assistance.
  
  By following these steps, you should be able to resolve the BSP_DLC_TOOLS2066 error and successfully access the configuration tool for mash-ups.