How To Fix BRAIN731 - Key figure &1 cannot be triggered

SAP Error Message - Details

• Message type: E = Error

• Message class: BRAIN -

• Message number: 731

• Message text: Key figure &1 cannot be triggered

What causes this issue?

Calculated key figure &1 contains variables with replacement paths or a
changed exception aggregation. The key figure cannot be explained
further here.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

You can look at the definition of the key figure in the Query Designer.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message BRAIN731 - Key figure &1 cannot be triggered ?

  The SAP error message BRAIN731, which states "Key figure &1 cannot be triggered," typically occurs in the context of SAP BW (Business Warehouse) or SAP Analytics when there is an issue with the configuration or usage of key figures in queries or reports.
  Cause:
  
  Key Figure Configuration: The key figure may not be properly configured in the InfoProvider or the query. This could be due to missing settings or incorrect data types.
  Data Source Issues: The data source for the key figure may not be available or may not contain the necessary data.
  Query Design: The key figure might not be included in the query definition or may be incorrectly referenced.
  Authorization Issues: The user may not have the necessary authorizations to access the key figure.
  Aggregation Issues: If the key figure is supposed to be aggregated, there may be issues with the aggregation settings.
  
  Solution:
  
  Check Key Figure Configuration: Verify the configuration of the key figure in the InfoProvider. Ensure that it is correctly defined and that all necessary settings are in place.
  Validate Data Source: Ensure that the data source for the key figure is active and contains the required data. You can check the data in the underlying tables or InfoProviders.
  Review Query Design: Open the query in the Query Designer and ensure that the key figure is included and correctly referenced. Make sure that it is not set to be hidden or excluded from the output.
  Check Authorizations: Verify that the user has the necessary authorizations to access the key figure. This can be done through the user roles and authorizations in SAP.
  Examine Aggregation Settings: If the key figure is supposed to be aggregated, check the aggregation settings in the InfoObject definition to ensure they are correctly set up.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Documentation: Refer to the SAP BW documentation for information on key figures, InfoProviders, and query design.
  Community Forums: Look for discussions in SAP community forums or SAP support channels where similar issues may have been addressed.
  
  If the issue persists after checking these areas, it may be beneficial to consult with an SAP BW expert or reach out to SAP support for further assistance.