How To Fix AW466 - Correct display of values in dep. area &1 not possible: &2 missing in &3

SAP Error Message - Details

• Message type: E = Error

• Message class: AW - AuC messages

• Message number: 466

• Message text: Correct display of values in dep. area &1 not possible: &2 missing in &3

What causes this issue?

The values in depreciation area &v1& cannot be displayed, or cannot be
completely displayed, because field &v2& is not visible in current
layout &v3&.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Select a layout in which at least the following fields are visible for
display of the additional depreciation area:
Posting amount in additional area
Additional currency
The following fields can be displayed as additional information for the
additional depreciation area:
Additional depreciation area
Short text of addit. depreciation area

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message AW466 - Correct display of values in dep. area &1 not possible: &2 missing in &3 ?

  The SAP error message AW466 indicates that there is an issue with the display of values in a specific depreciation area. The message typically means that a required value is missing for a particular asset in the specified depreciation area. Here’s a breakdown of the components of the error message:
  
  
  Cause: The error occurs when the system cannot find the necessary data for the specified depreciation area. This could be due to several reasons, such as:
  
  Missing configuration for the depreciation area.
  Missing or incomplete asset master data.
  Incorrect settings in the asset accounting configuration.
  The asset may not have been fully processed or posted in the system.
  
  
  
  Solution: To resolve this error, you can take the following steps:
  
  Check Asset Master Data: Verify that the asset master data is complete and correctly configured for the specified depreciation area. Ensure that all required fields are filled in.
  Review Depreciation Area Configuration: Go to the configuration settings for asset accounting and check if the depreciation area is properly set up. Ensure that all necessary settings are in place.
  Check for Missing Values: Identify what specific value is missing (as indicated by the placeholders &2 and &3 in the error message) and ensure that it is populated in the asset master data.
  Run Asset Reports: Use asset reports to identify any inconsistencies or missing data related to the asset in question.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the depreciation area and the required settings.
  
  
  
  Related Information: 
  
  The error message can be triggered in various transactions related to asset accounting, such as asset postings, reporting, or during the execution of depreciation runs.
  It is important to have the necessary authorizations to view and edit asset master data and configuration settings.
  If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  
  
  By following these steps, you should be able to identify and resolve the underlying issue causing the AW466 error message in SAP.