How To Fix ATP_SUP_LOGIC050 - Characteristic &1 is used multiple times. This is not allowed.

SAP Error Message - Details

• Message type: E = Error

• Message class: ATP_SUP_LOGIC - Messages for ATP Supply Protection Logic

• Message number: 050

• Message text: Characteristic &1 is used multiple times. This is not allowed.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message ATP_SUP_LOGIC050 - Characteristic &1 is used multiple times. This is not allowed. ?

  The SAP error message ATP_SUP_LOGIC050 indicates that a characteristic is being used multiple times in the context of Advanced Planning (ATP) logic, which is not allowed. This typically occurs in scenarios involving the configuration of products, especially in variant configuration or when defining characteristics for planning purposes.
  Cause:
  
  Duplicate Characteristics: The error arises when the same characteristic is defined more than once in the context of a planning scenario, such as in a configuration profile or in the definition of a product variant.
  Incorrect Configuration: It may also occur due to incorrect settings in the configuration of the product or in the planning setup, where the same characteristic is inadvertently included multiple times.
  
  Solution:
  
  Review Characteristics: Check the configuration of the product or the planning setup to identify where the characteristic is being duplicated. Ensure that each characteristic is defined only once.
  Modify Configuration: If you find that a characteristic is indeed used multiple times, you will need to modify the configuration to ensure that each characteristic is unique within the context it is being used.
  Check Planning Profiles: If you are using planning profiles, ensure that the characteristics defined in the profile do not overlap or duplicate.
  Consult Documentation: Refer to SAP documentation or help resources for guidance on how to properly configure characteristics in your specific scenario.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CU01 (Create Configuration Profile) or CU02 (Change Configuration Profile) to review and modify the configuration settings.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on handling characteristics in ATP scenarios.
  Testing: After making changes, perform tests to ensure that the error is resolved and that the planning logic works as expected.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP expert or reach out to SAP support for further assistance.