How To Fix APOC_OC_CONFIG018 - Activation mode must not be empty.

SAP Error Message - Details

• Message type: E = Error

• Message class: APOC_OC_CONFIG - Output Control Configuration Messages

• Message number: 018

• Message text: Activation mode must not be empty.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message APOC_OC_CONFIG018 - Activation mode must not be empty. ?

  The SAP error message APOC_OC_CONFIG018 indicates that the activation mode for a certain configuration in the Advanced Planning and Optimization (APO) module is not set, which is causing the error. This typically occurs when you are trying to activate or configure a planning area or a similar object in SAP APO, and the system requires a specific activation mode to be defined.
  Cause:
  The error is caused by the absence of a defined activation mode in the configuration settings. The activation mode is essential for the system to understand how to process the data and perform the necessary operations.
  Solution:
  To resolve this error, you need to ensure that the activation mode is properly defined in the configuration settings. Here are the steps to do this:
  
  
  Access the Configuration Settings:
  
  Go to the SAP GUI and navigate to the relevant transaction code for configuring the planning area or object that is causing the error (e.g., /SAPAPO/MC90 for planning area configuration).
  
  
  
  Check Activation Mode:
  
  Look for the section where the activation mode is specified. This could be under a tab or section related to general settings or activation settings.
  
  
  
  Define the Activation Mode:
  
  If the activation mode is empty, select the appropriate activation mode from the available options. Common activation modes include:
  
  Full Activation: All data is activated.
  Delta Activation: Only changes are activated.
  
  
  Make sure to save your changes after defining the activation mode.
  
  
  
  Re-attempt the Activation:
  
  After setting the activation mode, try to activate the planning area or object again to see if the error persists.
  
  
  
  Related Information:
  
  Documentation: Refer to the SAP Help Portal or the specific documentation for SAP APO for detailed information on configuration settings and activation modes.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Support: If the issue persists after following the above steps, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  By ensuring that the activation mode is correctly set, you should be able to resolve the APOC_OC_CONFIG018 error and proceed with your configuration tasks in SAP APO.