How To Fix APOC_AUNIT_MESSAGES101 - The line type &1 of the mock data is not a DDIC type.

SAP Error Message - Details

• Message type: E = Error

• Message class: APOC_AUNIT_MESSAGES - Messages to be used in AUnit Infrastructure

• Message number: 101

• Message text: The line type &1 of the mock data is not a DDIC type.

What causes this issue?

The stub data for a CDS test should be typed by the underlying data
sources of the CDS view under test like views or data base tables.

System Response

The stub data could not be inserted.

How to fix this error?

Check the typing of the stub data to be inserted.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message APOC_AUNIT_MESSAGES101 - The line type &1 of the mock data is not a DDIC type. ?

  The SAP error message APOC_AUNIT_MESSAGES101 indicates that there is an issue with the line type of the mock data in the Advanced Planning and Optimization (APO) module. Specifically, it states that the line type specified is not a Data Dictionary (DDIC) type, which means that the system cannot recognize or process the line type as expected.
  Cause:
  
  Incorrect Line Type: The line type specified in the mock data may not be defined in the Data Dictionary. This could happen if the line type is misspelled, not created, or has been deleted.
  Configuration Issues: There may be configuration issues in the APO system that prevent the line type from being recognized.
  Data Consistency: The mock data being used may not be consistent with the expected formats or types defined in the system.
  
  Solution:
  
  
  Check Line Type Definition:
  
  Go to the Data Dictionary (transaction SE11) and check if the line type specified in the error message exists.
  Ensure that the line type is correctly defined and active.
  
  
  
  Correct the Mock Data:
  
  Review the mock data being used and ensure that the line type is correctly specified and matches the DDIC type.
  If necessary, update the mock data to use a valid line type.
  
  
  
  Configuration Review:
  
  Check the configuration settings in the APO system to ensure that all necessary settings related to line types are correctly configured.
  If you have recently made changes to the configuration, consider reverting those changes to see if it resolves the issue.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to APO and line types for any specific requirements or known issues.
  
  
  
  Testing:
  
  After making the necessary corrections, test the process again to see if the error persists.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  APO Documentation: Review the official SAP APO documentation for guidelines on working with mock data and line types.
  Community Forums: Consider searching or posting in SAP community forums for insights from other users who may have encountered similar issues.
  
  If the problem persists after following these steps, it may be beneficial to engage with SAP support for further assistance.