How To Fix AH030 - Measured pressure &1 is greater than maximum value &2

SAP Error Message - Details

• Message type: E = Error

• Message class: AH - IS-U billing (master data)

• Message number: 030

• Message text: Measured pressure &1 is greater than maximum value &2

What causes this issue?

You have entered a measured pressure that exceeds the maximum value
permitted.

How to fix this error?

If the measured pressure is <ZH>not</> to exceed the maximum value
permitted, then enter a lower measured pressure.
If the measured pressure <ZH>is</> to exceed the maximum value
permitted, then proceed as follows:
Call the <LS>Measured pressure</> table for the billing class in the
present volume correction factor procedure.
Extend the table to include new permissible measured pressure values
for this billing class.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message AH030 - Measured pressure &1 is greater than maximum value &2 ?

  The SAP error message AH030 indicates that the measured pressure value exceeds the maximum allowable limit defined in the system. This error typically occurs in the context of process control, measurement, or monitoring within SAP systems, particularly in modules related to plant maintenance, production planning, or quality management.
  Cause:
  
  Exceeding Maximum Limit: The primary cause of this error is that the measured pressure value (indicated by &1) is greater than the maximum permissible value (indicated by &2) set in the system.
  Incorrect Sensor Calibration: The sensors or measurement devices may be incorrectly calibrated, leading to inaccurate readings.
  Data Entry Error: Manual entry of pressure values may have resulted in an incorrect value being inputted into the system.
  System Configuration: The maximum pressure limit may not be configured correctly in the system settings.
  
  Solution:
  
  Check Measured Value: Verify the actual measured pressure value to ensure it is accurate. If the measurement is indeed correct, investigate the system settings.
  Review Maximum Limit Settings: Check the configuration settings in SAP for the maximum pressure limit. This can usually be found in the relevant configuration tables or settings for the specific module you are working with.
  Calibrate Sensors: If the sensors are found to be faulty or incorrectly calibrated, recalibrate or replace them as necessary.
  Correct Data Entry: If the error was due to incorrect manual data entry, correct the value in the system.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on handling this error in your particular module or context.
  Contact Support: If the issue persists after checking the above points, consider reaching out to SAP support or your internal IT team for further assistance.
  
  Related Information:
  
  SAP Modules: This error may be encountered in modules such as SAP PM (Plant Maintenance), SAP PP (Production Planning), or SAP QM (Quality Management).
  Transaction Codes: You may need to use specific transaction codes to access configuration settings or measurement records, such as OISD (for measuring points) or other relevant transaction codes based on your SAP version.
  Documentation: Always refer to the latest SAP Notes and documentation for updates or patches that may address known issues related to measurement errors.
  
  By following these steps, you should be able to identify the cause of the AH030 error and implement a suitable solution.