How To Fix AFWGO_MESSAGES067 - The two base key figures for &1 do not use the same base key figure/NPV

SAP Error Message - Details

• Message type: E = Error

• Message class: AFWGO_MESSAGES - Messages for Development Class AFWGO

• Message number: 067

• Message text: The two base key figures for &1 do not use the same base key figure/NPV

What causes this issue?

With yield key figures you have to make sure that both preceding key
figures stem from the same base key figure NPV.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Choose two preceding key figures that stem from the same base key
figure NPV .

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message AFWGO_MESSAGES067 - The two base key figures for &1 do not use the same base key figure/NPV ?

  The SAP error message AFWGO_MESSAGES067 indicates that there is a mismatch between the base key figures used in a specific calculation or configuration. This error typically arises in the context of SAP Analytics or SAP BW (Business Warehouse) when working with key figures in planning or reporting scenarios.
  Cause:
  The error occurs when two base key figures that are supposed to be used together in a calculation or aggregation do not share the same base key figure or Non-Planning Value (NPV). This can happen due to:
  
  Configuration Issues: The key figures may have been configured incorrectly in the planning model or data model.
  Inconsistent Data Sources: The key figures may be pulling data from different sources or contexts that do not align.
  Modeling Errors: There may be errors in the way the key figures are defined or related to each other in the data model.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Key Figure Definitions: Review the definitions of the key figures involved. Ensure that both key figures are set up to use the same base key figure or NPV.
  
  
  Review Planning Model: If you are using a planning model, check the configuration of the model to ensure that the key figures are correctly linked and that their properties are consistent.
  
  
  Data Source Alignment: Ensure that both key figures are pulling data from compatible sources. If they are meant to be aggregated or calculated together, they should originate from the same data context.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the key figures and their configurations.
  
  
  Testing: After making changes, test the configuration to ensure that the error is resolved and that the calculations are functioning as expected.
  
  
  Seek Support: If the issue persists, consider reaching out to SAP support or consulting with a technical expert who specializes in SAP BW or Analytics.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  Training Resources: Consider training or documentation on key figure modeling in SAP BW or Analytics to better understand how to configure and troubleshoot these types of issues.
  
  By following these steps, you should be able to identify the root cause of the error and implement a solution to resolve it.