How To Fix ADPTM205 - Unit inconsistence of operation &1 in order &2

ADPTM205 - Overview

• Message type: E = Error

• Message class: ADPTM - Message Class for Component Maintenance Cockpit

• Message number: 205

• Message text: Unit inconsistence of operation &1 in order &2

What causes this issue?

There is a problem corresponding to the duration unit given in the
operation of the PM / CS order .
The error can be caused by the following problems:
The unit is missing in the order
The dimension of the unit is not a time dimension (such as Hours or
Days)
The corresponding customizing entry (T006) is missing

System Response

The CMC can not be started with this order.

How to fix this error?

There are two possibilities to avoid the error:
Check the corresponding order / operation and adjust the unit
Exclude the order from the CMC selection list

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message ADPTM205 - Unit inconsistence of operation &1 in order &2 ?

  The SAP error message ADPTM205, which states "Unit inconsistency of operation &1 in order &2," typically indicates that there is a mismatch in the units of measure for a specific operation within a production order or maintenance order. This inconsistency can arise from various factors, such as incorrect unit definitions, discrepancies between the order and the master data, or issues during the planning phase.
  Causes:
  
  Unit of Measure Mismatch: The unit of measure defined for the operation does not match the unit of measure defined for the material or the order.
  Incorrect Master Data: The material master or the routing may have incorrect or inconsistent unit definitions.
  Changes in Master Data: If the unit of measure for a material or operation was changed after the order was created, it could lead to inconsistencies.
  
  Configuration Issues: There may be configuration issues in the system that lead to incorrect unit of measure settings.
  
  Solutions:
  
  Check the Operation Details: Review