How To Fix AC528 - Depreciation area &1 in ch.of dep. &2 does not adopt values

SAP Error Message - Details

• Message type: E = Error

• Message class: AC - Error messages from Asset Customizing

• Message number: 528

• Message text: Depreciation area &1 in ch.of dep. &2 does not adopt values

What causes this issue?

No reference depreciation area, from which values can be adopted, is
defined for depreciation area &V1& in chart of depreciation &V2&.
However, such an area is required for posting, and is expected by the
system.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Define a reference depreciation area for the transfer of values to
depreciation area &V1&.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message AC528 - Depreciation area &1 in ch.of dep. &2 does not adopt values ?

  The SAP error message AC528 indicates that there is an issue with the depreciation area in the asset accounting module. Specifically, it means that the specified depreciation area (denoted by &1) in the chart of depreciation (denoted by &2) is not adopting the expected values during the depreciation run or asset posting.
  Cause:
  The error can occur due to several reasons, including:
  
  
  Configuration Issues: The depreciation area may not be properly configured in the chart of depreciation. This could include missing settings for the depreciation method, useful life, or other parameters.
  
  
  Inconsistent Data: There may be inconsistencies in the asset master data, such as missing or incorrect values in the depreciation area settings.
  
  
  Locked or Inactive Depreciation Area: The depreciation area might be locked or inactive, preventing it from adopting values.
  
  
  Posting Period Issues: The posting period for the depreciation run may not be open, or there may be restrictions on posting to that particular depreciation area.
  
  
  Asset Class Settings: The asset class associated with the asset may not be configured to allow for the specified depreciation area.
  
  
  Solution:
  To resolve the AC528 error, you can take the following steps:
  
  
  Check Configuration:
  
  Go to the configuration settings for the chart of depreciation and ensure that the depreciation area is correctly set up.
  Verify that the depreciation method, useful life, and other relevant parameters are correctly defined.
  
  
  
  Review Asset Master Data:
  
  Check the asset master record for the asset in question. Ensure that all required fields for the depreciation area are filled in correctly.
  Look for any inconsistencies or missing values.
  
  
  
  Check Depreciation Area Status:
  
  Ensure that the depreciation area is not locked or inactive. You can check this in the configuration settings.
  
  
  
  Verify Posting Period:
  
  Ensure that the posting period for the depreciation run is open. You can check this in the period control settings.
  
  
  
  Review Asset Class Settings:
  
  Check the asset class configuration to ensure that it allows for the specified depreciation area.
  
  
  
  Run the Depreciation Simulation:
  
  If applicable, run a depreciation simulation to see if the error persists and to identify any specific issues.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes such as OADB (for chart of depreciation) and AS02 (for asset master data) to access the relevant configuration and data.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Documentation: Refer to SAP documentation for asset accounting to understand the configuration and settings related to depreciation areas.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a functional consultant who specializes in asset accounting.