How To Fix 9J354 - No specification chosen for calculated measuring point for equipment &

SAP Error Message - Details

• Message type: E = Error

• Message class: 9J -

• Message number: 354

• Message text: No specification chosen for calculated measuring point for equipment &

What causes this issue?

No attributable counter reading entry was defined for the equipment.
definiert.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

If you require an attributable counter reading entry for the equipment,
create a measuring point for the equipment and in Customizing define
service entry (attributable) per document/service type.
Note:
If a measuring point has already been created for the equipment, check.
whether it has also been defined as a counter.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 9J354 - No specification chosen for calculated measuring point for equipment & ?

  The SAP error message 9J354, "No specification chosen for calculated measuring point for equipment &," typically occurs in the context of SAP Plant Maintenance (PM) or SAP Controlling (CO) when there is an issue with the configuration of measuring points or the specifications associated with them.
  Cause:
  
  Missing Specifications: The error indicates that there is no specification defined for the calculated measuring point associated with the equipment. This could happen if the specifications were not set up correctly in the system.
  Incorrect Configuration: The measuring point may not be properly configured in the system, leading to the inability to determine the correct specification.
  Data Inconsistency: There may be inconsistencies in the data related to the equipment or measuring points, such as missing entries in the relevant tables.
  
  Solution:
  
  
  Check Measuring Point Configuration:
  
  Navigate to the measuring point configuration in SAP (Transaction Code: IK01/IK02).
  Ensure that the measuring point is correctly defined and that the specifications are assigned to it.
  
  
  
  Define Specifications:
  
  If specifications are missing, you need to create them. Go to the relevant configuration area (Transaction Code: OIK1 for measuring point specifications) and define the necessary specifications for the calculated measuring point.
  
  
  
  Review Equipment Master Data:
  
  Check the equipment master data (Transaction Code: IE02) to ensure that all necessary fields are filled out correctly and that the equipment is linked to the correct measuring points.
  
  
  
  Check for Data Consistency:
  
  Use transaction codes like SE16 or SE11 to check the relevant database tables for any inconsistencies or missing entries related to measuring points and specifications.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help files related to measuring points and specifications to ensure that you are following the correct procedures.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance, as they may provide insights specific to your system configuration.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  IK01: Create Measuring Point
  IK02: Change Measuring Point
  IK03: Display Measuring Point
  OIK1: Define Measuring Point Specifications
  IE01/IE02: Create/Change Equipment
  
  
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  
  
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  
  By following these steps, you should be able to identify and resolve the cause of the error message 9J354 in your SAP system.