How To Fix 9J351 - Only one measuring point (&2) found for equipment &1

SAP Error Message - Details

• Message type: E = Error

• Message class: 9J -

• Message number: 351

• Message text: Only one measuring point (&2) found for equipment &1

What causes this issue?

Only one measuring point could be found for this piece of equipment.
Due to the Customizing settings under "Activity Entry (Actual and
Calculated) per Document Type/Activity Type", you must enter a second
measuring point.

How to fix this error?

Please define a second measuring point for the piece of equipment or
change the Customizing settings.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 9J351 - Only one measuring point (&2) found for equipment &1 ?

  The SAP error message 9J351 ("Only one measuring point (&2) found for equipment &1") typically occurs in the context of SAP Plant Maintenance (PM) or SAP Controlling (CO) when you are trying to perform an operation that requires multiple measuring points for a piece of equipment, but only one measuring point is found in the system.
  Cause:
  
  Single Measuring Point: The equipment in question has only one measuring point defined in the system. This can happen if the measuring points were not set up correctly or if the equipment is not configured to have multiple measuring points.
  Configuration Issues: There may be a configuration issue in the measuring point setup for the equipment.
  Data Entry Error: There might be an error in the data entry process where multiple measuring points were expected but only one was created.
  
  Solution:
  
  Check Measuring Points: Go to the measuring point master data for the equipment in question and verify how many measuring points are defined. You can do this using transaction code IK03 (Display Measuring Point) or IK01 (Create Measuring Point) to see the details.
  Create Additional Measuring Points: If you need multiple measuring points, you can create additional measuring points for the equipment using transaction code IK01. Ensure that the measuring points are correctly configured and associated with the right equipment.
  Review Equipment Configuration: Check the equipment configuration to ensure that it is set up to allow for multiple measuring points. This may involve reviewing the equipment master data and settings.
  Consult Documentation: Refer to SAP documentation or your organization's internal guidelines for setting up measuring points to ensure compliance with best practices.
  
  Related Information:
  
  Transaction Codes:
  
  IK01: Create Measuring Point
  IK02: Change Measuring Point
  IK03: Display Measuring Point
  IE03: Display Equipment
  
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional guidance.
  User Roles and Authorizations: Ensure that the user has the necessary authorizations to create or modify measuring points.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a functional consultant who specializes in SAP PM or CO for further assistance.