How To Fix 70035 - A rounding divisor without a rounding type was entered in table &1

SAP Error Message - Details

• Message type: E = Error

• Message class: 70 - HR: Messages in Master Data Reporting

• Message number: 035

• Message text: A rounding divisor without a rounding type was entered in table &1

What causes this issue?

If you make an entry for table &V1& in the <LS>RoDiv</> (Rounding
Divisor) field, then you also have to make one in the <LS>RoTyp</>
(Rounding Type) field.

How to fix this error?

Either delete your entry from the <LS>RoDiv</> (Rounding Divisor)
field, or enter an additional rounding type.
You will find further information about pay scale currency conversion
in the documentation of report <DS:RE.RPUEMU00>RPUEMU00</>.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 70035 - A rounding divisor without a rounding type was entered in table &1 ?

  The SAP error message 70035, "A rounding divisor without a rounding type was entered in table &1," typically occurs in the context of financial or controlling modules where rounding rules are defined. This error indicates that there is a rounding divisor defined in a specific table (denoted by &1) without an associated rounding type, which is necessary for the system to process rounding correctly.
  Cause:
  
  Missing Rounding Type: The rounding divisor has been defined in the configuration but lacks a corresponding rounding type. This can happen if the configuration was not completed properly or if there was an oversight during the setup.
  Incorrect Configuration: The configuration settings in the relevant tables (like T001, T006, etc.) may not have been set up correctly, leading to inconsistencies.
  Data Entry Error: Manual entries in the configuration tables may have been made incorrectly, leading to this error.
  
  Solution:
  
  
  Check Configuration: 
  
  Go to the relevant configuration transaction (like SPRO) and navigate to the area where rounding rules are defined.
  Ensure that all rounding divisors have a corresponding rounding type assigned.
  
  
  
  Update the Table:
  
  If you identify a rounding divisor without a rounding type, you will need to either assign a valid rounding type or remove the divisor if it is not needed.
  Use transaction codes like SE11 (Data Dictionary) or SE16 (Data Browser) to view and edit the relevant tables.
  
  
  
  Consult Documentation: 
  
  Review SAP documentation or help files related to the specific module you are working with to understand the correct setup for rounding rules.
  
  
  
  Testing: 
  
  After making changes, perform tests to ensure that the error no longer occurs and that the rounding calculations are functioning as expected.
  
  
  
  Transport Changes: 
  
  If changes are made in a development environment, ensure that they are transported to the production environment following your organization's change management procedures.
  
  
  
  Related Information:
  
  Rounding Types: Rounding types define how values are rounded (e.g., up, down, nearest). Ensure that the rounding types are correctly defined in the system.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on rounding configurations.
  User Exits or BAdIs: If custom logic is involved, review any user exits or BAdIs that may affect rounding behavior.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP functional consultant or reach out to SAP support for further assistance.