How To Fix 5D530 - Standard flat-rate rax (IT0012) doesn't match pension insurance ind. &4

SAP Error Message - Details

• Message type: E = Error

• Message class: 5D - Error Messages for German Infotype Module Pools

• Message number: 530

• Message text: Standard flat-rate rax (IT0012) doesn't match pension insurance ind. &4

What causes this issue?

In the tax infotype (0012), the standard flat-rate tax is entered from
&V1& to &V1&. The standard flat-rate tax can be used only if the
employer makes flat-rate contributions to the pension insurance as part
of low-paying job.
However, this does not apply to the SI attribute &V3& and the PI
indicator &V3&.

System Response

The current infotype record cannot be saved.

How to fix this error?

Exit the current infotype record without saving and adjust the taxation
in the tax infotype (0012).

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 5D530 - Standard flat-rate rax (IT0012) doesn't match pension insurance ind. &4 ?

  The SAP error message 5D530 indicates that there is a mismatch between the standard flat-rate tax (IT0012) and the pension insurance indicator in the employee's master data. This error typically arises during payroll processing when the system checks the consistency of the tax and pension insurance data.
  Cause:
  
  Data Mismatch: The standard flat-rate tax defined in the employee's tax data (IT0012) does not align with the pension insurance indicator set in the employee's master data.
  Incorrect Configuration: There may be incorrect configuration in the payroll schema or tax settings that leads to this inconsistency.
  Missing or Incorrect Entries: The employee's master data may have missing or incorrect entries related to tax or pension insurance.
  
  Solution:
  
  
  Check Employee Master Data:
  
  Go to the employee's master data (Transaction PA30).
  Review the entries in Infotype 0012 (Standard Flat-Rate Tax) and Infotype 0014 (Recurring Payments/Deductions) to ensure they are correctly filled out.
  Verify the pension insurance indicator in Infotype 0010 (Employee Actions) or Infotype 0011 (External Data) to ensure it matches the tax data.
  
  
  
  Review Configuration:
  
  Check the configuration settings for tax and pension insurance in the SAP system. Ensure that the settings for flat-rate tax and pension insurance are correctly defined in the payroll schema.
  Consult with your SAP payroll consultant or administrator to ensure that the tax and pension insurance settings are aligned with the legal requirements.
  
  
  
  Correct Data Entries:
  
  If discrepancies are found, correct the entries in the relevant infotypes.
  Ensure that the pension insurance indicator is set correctly based on the employee's tax status.
  
  
  
  Run Payroll Simulation:
  
  After making the necessary corrections, run a payroll simulation to check if the error persists.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to payroll processing and tax calculations for further guidance.
  
  
  
  Related Information:
  
  Infotypes: Familiarize yourself with the relevant infotypes (IT0012, IT0010, IT0011, IT0014) that are involved in tax and pension insurance processing.
  SAP Notes: Check for any SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Legal Requirements: Ensure compliance with local tax laws and pension regulations, as these can affect how data should be entered in the system.
  
  If the issue persists after following these steps, it may be necessary to engage with SAP support or a qualified SAP consultant for further assistance.