How To Fix 54271 - Report &1 has LDB &2, however report category &3 is valid for LDB &4

54271 - Overview

• Message type: E = Error

• Message class: 54 - Messages for HR tables

• Message number: 271

• Message text: Report &1 has LDB &2, however report category &3 is valid for LDB &4

What causes this issue?

The &V1& report uses the &V2& logical database. Here, the report is
assigned the &V3& report class, which is valid for the &V4& logical
database.

System Response

The system outputs a warning.

How to fix this error?

Check if the report class should actually be assigned to this report.
If the assignment of report class and report to the PNPCE logical data
base does not agree, the wrong parameters that are specific to the PNPCE
may be incorrectly used during the program run.
If necessary, copy the report class if you want to use it for PNP and
PNPCE reports.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 54271 - Report &1 has LDB &2, however report category &3 is valid for LDB &4 ?

  The SAP error message 54271 indicates a mismatch between the logical database (LDB) associated with a report and the report category that is valid for that logical database. This error typically occurs when a report is trying to use a logical database that is not compatible with the specified report category.
  
  Cause:
  
  Logical Database Mismatch: The report is linked to a logical database (LDB) that does not correspond to the report category defined in the report attributes.
  Incorrect Report Category: The report category specified in the report does not match the expected category for the logical database being used.
  
  Configuration Issues: There may be configuration issues in the report settings or in the logical database definitions.
  
  
  Solution:
  
  
  Check Report Attributes:
  
  Go to the report in the ABAP Workbench (SE38 or SE80).
  Check the report attributes to see which logical database is assigned and what report category is set.
  
  
  
  Verify Logical Database:
  
  Ensure that the logical database assigned to the report