How To Fix 34N642 - All requirements for characteristic "&2" in "&1"

34N642 - Overview

• Message type: E = Error

• Message class: 34N - Messages for AP Configuration Engine

• Message number: 642

• Message text: All requirements for characteristic "&2" in "&1"

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message 34N642 - All requirements for characteristic "&2" in "&1" ?

  The SAP error message 34N642 indicates that there are unmet requirements for a specific characteristic in a configuration scenario. This error typically arises in the context of variant configuration, where certain characteristics must be fulfilled based on the dependencies defined in the configuration model.
  
  Cause:
  The error message 34N642 is triggered when:
  
  A characteristic (denoted as "&2") is required for a specific object (denoted as "&1"), but the necessary conditions or dependencies for that characteristic are not satisfied.
  This can happen if:
  The characteristic is not assigned to the configuration profile.
  The dependencies (like constraints or selection conditions) that govern the characteristic are not met.
  The characteristic is not set or is set to an invalid value.
  
  
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Configuration Profile:
  
  Ensure that the characteristic "&2" is included in the configuration profile for the object "&1".
  Go to the configuration profile settings and verify the characteristics assigned.
  
  
  
  Review Dependencies:
  
  Examine the dependencies (e.g., constraints,