How To Fix 2B001 - Job &1 does not meet TMS naming conventions

2B001 - Overview

• Message type: E = Error

• Message class: 2B - TMS Background Service

• Message number: 001

• Message text: Job &1 does not meet TMS naming conventions

What causes this issue?

Jobs created by TMS are named according to the following naming
convention:
TMS_<ten-figure number>
The name of the job &V1& does not fit this convention.

System Response

The function terminates.

How to fix this error?

Make sure that you use TMS jobs only.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message 2B001 - Job &1 does not meet TMS naming conventions ?

  The SAP error message 2B001 indicates that a job (in this case, a background job) does not meet the naming conventions defined in the Transport Management System (TMS). This error typically arises when the job name does not conform to the expected format or rules set by the TMS configuration.
  
  Cause:
  The error can occur due to several reasons:
  
  Invalid Characters: The job name may contain invalid characters that are not allowed by TMS naming conventions.
  Length Restrictions: The job name may exceed the maximum length allowed by TMS.
  Prefix/Suffix Requirements: The job name may not start or end with the required prefixes or suffixes as defined in the TMS settings.
  
  Configuration Issues: There may be specific configurations in TMS that dictate how job names should be structured.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Naming Conventions: Review the naming conventions for jobs in your TMS configuration. This can usually be found in the