How To Fix WXCM101 - Zwischen den Attributen besteht eine zirkuläre Abhängigkeit

WXCM101 - Overview

• Message type: E = Error

• Message class: WXCM - Messages for Package CM_MAP

• Message number: 101

• Message text: Zwischen den Attributen besteht eine zirkuläre Abhängigkeit

<ZH>&CAUSE&</>
With the context structures for the attributes in the planning
hierarchy, you define the characteristics on which the characteristic
values of the attribute are dependent. Through this dependency of
attributes, a sequence is determined, in which the characteristic
values of the attributes are defined.
In principle, it is possible that the characterisitc value of an
attribute is dependent on the characteristic value of another
attribute. In certain cases, this leads to the problem of <ZK>circular
dependencies</>.
<ZH>Example:</>
The levels material group (MATKL), country (LAND) and branch (WERKS)
are contained in the planning hierarchy. The planning level material
group is a component of the specified master data hierarchy. The
country and branch are not contained in the master data hierarchy. They
are, therefore, attributes.
The planning level WERKS must contain all branches that have the
corresponding material groups within the particular country (LAND) in
their assortment. For the attribute WERKS, the context structure
therefore contains the planning levels MATKL (component of the master
data hierarchy) and LAND (attribute)
You still have to determine how the attribute LAND is to be filled. If
you want to see the country independently of the branches (perhaps to
determine the country of the branch from the adress data), the
following occurs: The context structure for the attribute LAND contains
the attribute WERKS. This is in accordance with its context structure
but in turn it is dependent on the attribute LAND!
This is a circular dependency: Between attributes there is a chain of
mutual dependencies, without a "start" in the chain:
Attr1 -> Attr2 -> .... -> AttrN -> Attr1.
In the case of circular dependencies, the system cannot determine the
attributes to be defined or in what order.

Systemantwort

The system could not create the planning hierarchy.

Wie behebe ich diesen Fehler?

Check the relevant context structures for the attributes. Remove the
circular dependencies and begin constructing the planning hierarchy
from master data again.

Vorgehensweise für Systemadministratoren

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE