How To Fix UPC201 - InfoCube &1 ist nicht vorhanden

SAP Error Message - Details

• Message type: E = Error

• Message class: UPC - Planning: General Error Messages

• Message number: 201

• Message text: InfoCube &1 ist nicht vorhanden

Was verursacht dieses Problem?

You have attempted to carry out changes in a planning area. However,
the system could not find the InfoCube which is assigned to the
planning area.

Systemantwort

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Wie behebe ich diesen Fehler?

Check the definition of the planning area. Possible causes could be:
The InfoCube it is based on was deleted. In this case you can no longer
use the planning area. You should delete the area and if necessary,
form a new InfoCube.
The InfoCube it is based on does not have the status 'active'
The InfoCube it is based on was renamed in SAP BW, after it was
assigned the planning area.
If the InfoCube is in another system: The RFC destination, through
which a connection was formed to the remote system, was changed,
renamed or deleted.
If the InfoCube is in another system: The connection to the remote
system can not be established due to hardware problems.
If you cannot ascertain the problem it is based on, then notify your
system administrator.

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE