How To Fix UGWB023 - Veränderte Reihenfolge durch Umhängen

UGWB023 - Overview

• Message type: E = Error

• Message class: UGWB - Messages for Workbench

• Message number: 023

• Message text: Veränderte Reihenfolge durch Umhängen

Was verursacht dieses Problem?

You dragged a node of the hierarchy to another node.
When this is done, the dragged node usually is assigned beneath the
target node. But, in this case, both nodes adjacently have the same
higher-level node; therefore, the positions of the nodes in the
hierarchy has been changed.

Systemantwort

When both the target node and the reassigned node are assigned to the
same, direct node, the system inserts the reassigned node at the same
level - before or behind the target node.
In this way, you are able to change the sequence of the entries that
are beneath the node.

Wie behebe ich diesen Fehler?

If you "insist" on inserting the reassigned node beneath the target
node, you can do one of the following:
First, temporarily assign the node under a node in another section of
the hierarchy. Then, from there you can drag it to the desired target
node.
Delete the node from the hierarchy and then insert it again.

Vorgehensweise für Systemadministratoren

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE