How To Fix QS081 - Klassenmerkmal und Stammprüfmerkmal passen nicht zusammen

SAP Error Message - Details

• Message type: E = Error

• Message class: QS - QM: Master data

• Message number: 081

• Message text: Klassenmerkmal und Stammprüfmerkmal passen nicht zusammen

Was verursacht dieses Problem?

You want to assign a class characteristic to the master inspection
characteristic after the master inspection characteristic was created.
The two characteristics, however, are not compatible.
The prerequisites that must be fulfilled in order to assign a class
characteristic depends on whether the class characteristic is of the
data type "<ZH>NUM</>" or "<ZH>CHAR</>."
If the general characteristic is of the data type "<ZH>NUM</>," the
following conditions must be fulfilled:
The master inspection characteristic must be <ZH>quantitative</>.
The two characteristics must have identical units of measurement, if a
unit is assigned to the class characteristic.
The control indicator for the upper specification limit and the control
indicator for the lower specification limit must be set in the master
inspection characteristic.
The interval limits for the class characteristic must be maintained as
follows:

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

<ZH>Master insp. characteristic</> <ZH>Class characteristic
</>
--------------------------------------------------------------------
Lower spec. limit only lower limit, no upper limit
Upper spec. limit only upper limit, no lower limit
Both specification limits both upper and lower limit
If the class characteristic is of the type "<ZH>CHAR</>," the following
conditions must be fulfilled:
A selected set from catalog type 1 was assigned to the class
characteristic.
The master inspection characteristic is <ZH>qualitative</>.
The "Characteristic attribute" indicator is set for the master
inspection characteristic.

Systemantwort

Wie behebe ich diesen Fehler?

Enter a class characteristic that is compatible with the master
inspection characteristic.

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE