How To Fix QD003 - Überlauf bei der Stichprobenermittlung

SAP Error Message - Details

• Message type: E = Error

• Message class: QD - Message-Id. für Dynamisierung

• Message number: 003

• Message text: Überlauf bei der Stichprobenermittlung

sample percentage rate.
Then recalculate the sampling determination for the affected inspection
lot using transaction QA02 "Change inspection lot".
For future inspection lots:
If you need to inspect a 100% of the lot size as the sample size,
ensure that the lot size does not exceed the maximum value possible.
material master, you cancel this setting and use a manual sample or a
If you defined a 100% inspection for the inspection type in the
calculated at sample determination.
that no value greater than the maximum possible (see above) is
procedure to the characteristic or characteristics in the task list, so
Change the assigned sampling procedure or assign a different sampling
For the current inspection lot

Wie behebe ich diesen Fehler?

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Systemantwort

based on the numeric data type.
the accepted percentage rate that exceeds the maximum value possible
If in sample determination an acceptance number was determined using
Or
sampling procedure or for an inspection type in the material master
If a sample percentage rate was entered for a characteristic in the
characteristic or an inspection procedure
If a 100% inspection is defined in the sampling procedure for a
If the inspection lot has a lot size that is greater
This error occurs:
(+2 billion; 2,147,483,647 to be exact).
that exceeded the maximum value possible based on the numeric data type
In sample determination, a value was determined for the sample size,

Was verursacht dieses Problem?

Make sure that the acceptance number determined using the assumed
percentage in percentage sampling procedures, does not exceed the
maximum value possible of 32,766.
Notes
Since the maximum print length of the fields for displaying the sample
size is limited to 8 characters, we recommend you make your settings,
so that no sample size greater than 99,999,999 is determined.
Also note, that the base quantity used in the sample determination can
be greater than the lot size as a result of conversion factors (for
example, if the sample quantity unit does not equal the base unit
measure).

Vorgehensweise für Systemadministratoren

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE