How To Fix PYC_CONF_WB018 - Semantischer Wert &1 ist für Alert-Abhängigkeit obsolet.

SAP Error Message - Details

• Message type: E = Error

• Message class: PYC_CONF_WB -

• Message number: 018

• Message text: Semantischer Wert &1 ist für Alert-Abhängigkeit obsolet.

Was verursacht dieses Problem?

You see this message because the semantic value for semantic category
<AB>PYD_NEED </>for the validation rule is not the ID of a filter
validation rule.
<ZH>Background</>
One validation rule Y can use another validation rule X as filter to
suppress the check results of Y. As a result, if an alert detected by Y
is already raised by validation rule X, the same alert will not be shown
by Y.
Prior to Configuration Workbench, this is implemented in Customizing
activity Define Check Types (under Customizing for <LS>Payroll ->
Payroll International -> Payroll Control Center -> Payroll Control
Center Configuration Simplification</>.)
For validation rule X, which is used as filter, assign the semantic
category <AB>PYD_CKFLTR </>and any pairing semantic value (for example,
ABCD).
For validation rule Y, which uses validation rule X as filter, assign
the semantic category <AB>PYD_NEED </>and the same pairing value (ABCD
in this case).
RESET N1
In Configuration Workbench, this is implemented by configuring alert
dependencies for validation rules:
Enable validation rule X as a filter by selecting the checkbox <LS>This
validation rule can be used by other validation rules to suppress raised
alerts </>on the <LS>Alert Dependencies </>tab page.
Add validation rule X in the alert dependencies of validation rule Y on
the <LS>Alert Dependencies </>tab page.
With Configuration Workbench, you no longer need to enter a pairing
value, but the validation rule ID is used automatically as the semantic
value for <AB>PYD_CKFLTR</> if the validation rule is used as a filter.

Systemantwort

This custom-paring-value implementation in Customizing activity is now
deprecated with the introduction of Configuration Workbench. With
Configuration Workbench, the pairing value is by default the ID of the
filter validation rule.

Wie behebe ich diesen Fehler?

Take the following steps:
RESET N1
Note down all the validation rules that are being used by validation
rule Y (<AB>PYD_NEED = ABCD</>) as filter are listed in the table
<LS>Don't raise an alert if any of the following validation rules has
already raised an alert</> in Configuration Workbench.
In Customizing activity <LS>Define Check Types </>(Types (under
Customizing for <LS>Payroll -> Payroll International -> Payroll Control
Center -> Payroll Control Center Configuration Simplification</>), for
each filter validation rule, change the semantic value of <AB>PYD_CKFLTR
</> <AB>= ABCD </>to <AB>PYD_CKFLTR</> <AB>= ID of filter validation
rule</>.
Back in Configuration Workbench (transaction code <AB>PYC_CONF_WB</>),
check and reassign the filter validation rules to validation rule Y.
The system changes the semantic value of <AB>PYD_NEED = ABCD</> for
validation rule Y to <AB>PYD_NEED = ID of each filter validation rule
</>.

Vorgehensweise für Systemadministratoren

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE