How To Fix GD228 - Parameter GRPID &1 nicht korrekt gesetzt.

SAP Error Message - Details

• Message type: E = Error

• Message class: GD - EDT: External data transfer

• Message number: 228

• Message text: Parameter GRPID &1 nicht korrekt gesetzt.

Was verursacht dieses Problem?

The field GRPID is blank or contains an incorrect value.

Wie behebe ich diesen Fehler?

The external data transfer always assumes that currency amounts are
transferred in currencies with 2 decimal places. However, because these
amounts may also be transferred in currencies with 0, 1, or 3 decimal
places, it is necessary to correct the decimal places accordingly. If
the currency amounts are already supplied from an SAP system in an SAP
format, the amounts have already been corrected, so no further decimal
place correction is required. The field GRPID must be set correctly to
make this known to the external data transfer during RFC transfers that
relay the data via the SAP memory. For file-based transfers, the field
is set according to the entries you make when you execute the external
data transfer.
Up to Release 4.6B, the valid values are:
'FILE' ,,,,,,-> with decimal place correction
'CPIC' ,,,,,,-> without decimal place correction
Starting with Release 4.6C, the valid values are:
'RFC1' ,,,,-> with decimal place correction
'RFC2' ,,,,-> without decimal place correction
Check for, and if necessary, add the following entries in table T242Y:
Starting with Release 4.6C
,,GRPID RFC1 ,,RFC2
SDEST
MANDTR
UNAME
PASSW
QUEUE
DRIVE
DECCO X
TEXT1 ,,,,,,Transfer without decimal place correction

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE