How To Fix DT075 - Tabelle & ist inkonsistent (Bitte bereinigen)

SAP Error Message - Details

• Message type: E = Error

• Message class: DT - Table activation (incl. indexes)

• Message number: 075

• Message text: Tabelle & ist inkonsistent (Bitte bereinigen)

Was verursacht dieses Problem?

The following inconsistencies are possible:
1. Table &V1& is not at the current status with regard to the domains/
data elements or included tables which it uses. This means that in the
last activation of the table as dependent the corresponding change to
the object in question could not be transferred to the table.
2. Table &V1& is included in another table. An error occurred in the
subsequent generation of the dependent tables. Table &V1& is therefore
set to partially active.
3. Table &V1& uses at least one check table or reference table which
does not exist, or it uses these incorrectly.
4. Table &V1& is used in views in which errors occurred during
activation as dependent objects.

Systemantwort

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Wie behebe ich diesen Fehler?

Analyze which of the above inconsistencies is the case, as follows:
1. Call <LS>Extras -> Database object -> Check</> or <LS>Extras ->
Runtime object-> Check</> in SE11 for table &V1& and make the
consistency check.
2. If you find an inconsistency, activate the object in question
(domain, data element or included table) again and/or convert table
&V1& if necessary.
3. If the analysis tool does not determine an inconsistency the table
should be checked in the ABAP Dictionary maintenance transaction. Here
any errors are named with regard to check or reference tables.
If such an error is the case, it must be corrected and table &V1& then
activated again.
4. If no error messages are given in the check in the ABAP Dictionary
maintenance transaction, either the diagnosis given above in point 2.
is the case, or the partial activity of the table is redundant
information. Check the number of dependent tables (when the table is
checked in the ABAP Dictionary maintenance transaction the dependent
tables are displayed). If there are less than 10 tables, activate table
&V1&.
Either &V1& is active after this activation or the log reports the
table causing the partial activty of &V1&. In the second case, correct
this dependent table and activate &V1& again. The partial activity
should in this case be eliminated.
Note to 4.: If there are more than 10 dependent objects, you should
execute the activation, if required, in the background. However, you
can equally well leave table &V1& partially active. It can be used in
its partially active status without difficulties because the partial
activity described in the diagnosis given in point 4. means there is no
information loss in table &V1&.

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE