How To Fix CPOC2029 - Selektionsbereich wurde auf &1 Herstell-/Arbeitsanweisungen begrenzt

SAP Error Message - Details

• Message type: E = Error

• Message class: CPOC2 - PP-PI-PMA: PI Sheet Messages, SCM Add-On

• Message number: 029

• Message text: Selektionsbereich wurde auf &1 Herstell-/Arbeitsanweisungen begrenzt

Was verursacht dieses Problem?

The number of PI sheets/work instructions to be selected was limited to
&V1& on the initial screen (see <LS>Max. Number of Entries</> field).
The selection was ended after this number was reached. It is therefore
possible that the worklist contains fewer PI sheets/work instructions
than actually exist.
<ZH>Note:</>
The selection of PI sheets/work instructions is carried out internally
in the following steps:
RESET N1
Selection of PI sheets/work instructions without taking the status of a
PI sheet/set of work instructions into account.
Fine selection from the hits determined in step 1 on the basis of the
status and the time period specified for the status <LS>New</>.
For technical reasons, the maximum number used on the initial screen
relates to step 1. Due to the subsequent fine selection, it may be that
the specified maximum number has not been reached in the worklist, but
nevertheless not all PI sheets/work instructions that actually exist are
displayed.

Systemantwort

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Wie behebe ich diesen Fehler?

RESET N1
Check and refine your selection criteria if need be.
If necessary, additionally increase the number of PI sheets/work
instructions on the initial screen for the worklist (<LS>Max. Number of
Entries</> field).
Note, however, that increasing the maximum number too much may lead to
performance problems.

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE