How To Fix CNV_20100094 - Ziel-Kostenart &2 existiert bereits; impliziter Merge durch Umbenennung

SAP Error Message - Details

• Message type: E = Error

• Message class: CNV_20100 - Messageclass for chart of account conversion

• Message number: 094

• Message text: Ziel-Kostenart &2 existiert bereits; impliziter Merge durch Umbenennung

Was verursacht dieses Problem?

When the cost elements that you plan to merge were checked, it was found
that target cost element &V2& (mapping &V1& -> &V2&) already exists on
the database.
However target cost element &V2& is not used as a source cost element (
&V2& -> XXXX) for another mapping relation.
This means that cost element &V1& is in fact merged with existing cost
element &V2& at chart of accounts-dependent cost element master data
level (CSKA, A level) as well as at controlling area-dependent cost
element master data level (CSKB, B level).

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

This has the following consequences. You need:
to find out if the implicit merge is correct from a logical point of
view
to explicitely include the entry &V2& -> &V2& to the mapping
to consider the priority indicator. If the priority indicator is not
set, it is not clear which settings will take priority when cost
elements &V1& and &V2& are merged into &V2&.

Wie behebe ich diesen Fehler?

<ZH>Regarding item 2:</>
Include the mapping &V2& -> &V2& into the mapping table so that at least
the following entries exist in the mapping table:
&V1& -> &V2&
&V2& -> &V2&
If applicable, any other mapping with target cost element &V2&.
This allows the system to check the merge for logical correctness.
A troubleshooting activity is associated to this activity which supports
you in creating the required mapping entries to resolve the implicit
merges.
<ZH>Regarding item 3:</>
Set the priority indicator for one of the entries for which &V2& is the
target cost element.
&NOTE&
It is possible to do the conversion without setting the priority
indicator. However then you should check the settings in A segment
(master data in chart of accounts, transaction FSP3) and B segment
(master data in controlling area, transaction FSS3) for the relevant
cost element &V2& after the conversion.
&ADDITIONAL_HINTS&
The priority indicator must not be set more than <ZH>once</> for all
merges to a given target cost element. This is also valid for
cross-chart of accounts merges.

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE