How To Fix CMX_POC_WI006 - Selektionsbereich wurde auf &1 Einträge begrenzt (siehe Langtext)

SAP Error Message - Details

• Message type: E = Error

• Message class: CMX_POC_WI - PP-PI-PMA: PI Sheet Messages, SCM Add-On

• Message number: 006

• Message text: Selektionsbereich wurde auf &1 Einträge begrenzt (siehe Langtext)

Was verursacht dieses Problem?

The number of sets of work instructions to be selected was limited to
&V1& on the initial screen (see specification <LS>Max. No. Work
Instructions</>). This specification has the following effects on the
selection steps performed internally:
RESET N1
Selection of work instructions without taking the status of a set of
work instructions into account:
The maximum number used on the initial screen relates to this step for
technical reasons. Step 1 was ended after this number was reached.
Fine selection from the number of hits determined in step 1 on the basis
of the status and the timespan specified in the case of the status
<ZK>New</>:
No work instructions satisfying the status requirements were found in
among the number of hits. The worklist thus remains empty. However, due
to the restriction effective in step 1, it is possible that not all
actually existing work instructions were taken into account.

Systemantwort

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Wie behebe ich diesen Fehler?

RESET N1
Check and narrow down your selection criteria if required.
If necessary, also increase the number of work instructions to be
selected when you call up the worklist (under <ZK>Max. Number of Work
Instructions</>.
However, note that increasing the maximum number too greatly can result
in performance problems.

Vorgehensweise für Systemadministratoren

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE