How To Fix AJ346 - Nicht plausibler Überlauf bei Gerät &1 Zw &2 Von-Datum &3 Bis-Datum &4

SAP Error Message - Details

• Message type: E = Error

• Message class: AJ - Billing program

• Message number: 346

• Message text: Nicht plausibler Überlauf bei Gerät &1 Zw &2 Von-Datum &3 Bis-Datum &4

Was verursacht dieses Problem?

For device &v1&, <ZK>register</> &v2&, the rounded meter reading for
date &v3& is greater than the rounded meter reading for date &v4&.
However, the amount of the difference is less than 1.
The error may have caused by an artificial meter overflow resulting from
the rounding. This problem may occur, for example, if the meter reading
rounding changed due to a rate change.

Systemantwort

This error can occur in billing in two processes:
During rounding of the actual meter reading results to the meter reading
rounding
During rounding of the meter reading results generated artificially as a
result of proration
In this case, the specified to-date &v4& is the proration date up to
which a result was calculated. This result is rounded and compared to
the result taken or calculated earlier. An artificial overflow was
determined in this process.

Wie kann das passieren?

You have recorded three meter readings. Two of them were read with three
decimal places. After the second result (10.957) was entered, the rate
changed, which resulted in a change in the meter reading rounding from
three to no decimal places (DP).
|-------------------|
0 3 DP 10.123
|------------------|
10.123 3 DP 10.957
|------------------|
10.957 0 DP 20
Rounding results in the following readings:
0 10.123 10 20
10.957 was rounded down to 10 (minimum of meter reading roundings 3 DP
and 0 DP). However, the reading is then lower than the previous reading
(10.123). As a result of the rounding, an artificial meter reading
overflow was generated.
The system cannot continue processing of the billing order.

Systemantwort

Das System gibt eine Fehlermeldung aus und erlaubt Ihnen nicht, mit dieser Transaktion fortzufahren, bis der Fehler behoben ist.

Wie behebe ich diesen Fehler?

Change the meter reading results in a way that rounding cannot result in
a meter overflow.
If the error resulted from artificially generated proration readings,
you can enter an estimated result for proration date &v4& or you can
change the results before and after the proration date in such a way
that the error does not occur (for example, you can manually round the
results down to zero decimal places).
Note
In some cases, the error can also occur in other situations, for
example, if an estimated meter reading exists in the database and there
is a meter overflow as a result of the next actual meter reading.
If this occurs, you can also use the procedure described above by adding
a new estimated meter reading or by changing the existing one.
We recommend that you also do this to replace obsolete estimatons with
more exact new estimations (for example, interpolation instead of
extrapolation).

Vorgehensweise für Systemadministratoren

Fehlermeldungsextrakt aus SAP-System. Copyright SAP SE