How To Fix FH610 - Ya existen datos variables en soc.CO "&1" p.clase coste "&2"

SAP Error Message - Details

• Message type: E = Error

• Message class: FH - General ledger module messages

• Message number: 610

• Message text: Ya existen datos variables en soc.CO "&1" p.clase coste "&2"

¿Qué causa este problema?

You want to make changes to the <DS:DE.FKBER>functional area</> '&V4&'
in the master data, although postings have already been made using this
functional area.
Cost element '&V2&' is also used in controlling area '&V1&', which is
assigned to the same chart of accounts '&V3&'. Transaction date already
exists for this.

Respuesta del sistema

If you make changes to the functional area, future postings will be made
using the new functional area. The changes made to the functional area
have no effect on postings that have already been made. Thismeans that
the functional area cannot be changed.

¿Cómo arreglar este error?

If you have no choice but to make changes to the functional area, you
can proceed in accordance with OSS note 115840.
Note
Changes to the functional area can lead to inconsistencies if documents
are reversed. If, subsequent to the functional area being changed,
documents are reversed that were posted before the functional area was
changed, the reversal document might be posted under the new functional
area.

Procedimiento para Administradoras de Sistemas

In the standard system, the message appears as an error message.
You can, however, change the message type. To do so, call up Customizing
and choose Controlling -> General Controlling ->
<DS:SIMG.SIMG_CFMENUORK3OBA5>Change Message Control</>.
Caution
This message appears when a functional area is changed in various master
data, such as cost centers, internal orders or G/L accounts. If you
change or switch off the message type for this message irrespective of
the user name, this change then takes effect in all programs where the
message is used.
Unfortunately, this can also lead to the message not being sent at all,
if you change the message type for this message to "warning" or
"information". This is the case if you change the functional area is
certain master data in the project system.
SAP therefore recommends that you do the following
Change the message type of this message for special users only
After you have changed the functional area, reset the message type to
"E" for error.

Extracto de mensaje de error del sistema SAP. Copyright SAP SE.