How To Fix AH689 - Rutina &1 programa de Include &2: Parámetro &3 inicial

SAP Error Message - Details

• Message type: E = Error

• Message class: AH - IS-U billing (master data)

• Message number: 689

• Message text: Rutina &1 programa de Include &2: Parámetro &3 inicial

¿Qué causa este problema?

During conversion of units of measurement in a dimension, the system
established that not all required units of measurement have been
specified.

Respuesta del sistema

Processing is canceled.

¿Cómo arreglar este error?

Check whether one of the following causes applies:
The units of measurement for meter reading and for billing need to be
specified.
If gas billing is to occur, the units of measurement in the volume
correction factor procedure and the calorific value procedure also need
to be maintained. In each of these procedures the following units of
measurement should be the same, or at least fall within the same
dimensions.
Unit of measurement for meter reading and unit of measurement before
conversion of volume correction factor (such as M3)
Unit of measurment after conversion of volume correction factor and
unit of measurement before conversion of calorific value (such as NM3)
Unit of measurement after conversion of calorific value and unit of
measurement for billing (such as KWh)
If you do not find any errors here, the problem could be due to an
internal error. If this is the case, contact SAP.

Extracto de mensaje de error del sistema SAP. Copyright SAP SE.