How To Fix XC300 - &1: Inspection lot integration only possible as of SAP APO 4.0

SAP Error Message - Details

• Message type: E = Error

• Message class: XC - Message Class for Core Interface

• Message number: 300

• Message text: &1: Inspection lot integration only possible as of SAP APO 4.0

What causes this issue?

You have attempted to set inspection lot integration for system &V1&.
However, this system is set to a release level of &V2& and inspection
lot integration is only supported as of SAP APO 4.0.

System Response

The setting is saved. However, you should be aware that this setting
will lead to transfer errors if your SAP APO release is actually lower
than SAP APO 4.0.

How to fix this error?

Ensure that the correct release has been entered for system &V1&. You
can make this setting in C
Setting up the System Landscape</> -> <ls>Specify SAP APO Release</>
(transaction <DS:TRAN.NDV2>NDV2</>). In this transaction, choose the
required valid setting.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message XC300 - &1: Inspection lot integration only possible as of SAP APO 4.0 ?

  The SAP error message "XC300 &1: Inspection lot integration only possible as of SAP APO 4.0" typically indicates that there is an issue with the integration of inspection lots in the SAP Advanced Planning and Optimization (APO) system. This error arises when the system attempts to perform operations related to inspection lots, but the version of SAP APO being used is older than 4.0, which does not support this functionality.
  Cause:
  
  Version Compatibility: The primary cause of this error is that the version of SAP APO you are using is below 4.0. Inspection lot integration features were introduced in SAP APO 4.0, and earlier versions do not support this functionality.
  Configuration Issues: There may be configuration settings in the system that are not aligned with the requirements for inspection lot integration.
  Data Transfer Issues: If there are issues with the data being transferred between SAP ERP and SAP APO, it may lead to this error.
  
  Solution:
  
  Upgrade SAP APO: The most straightforward solution is to upgrade your SAP APO system to version 4.0 or higher. This will enable the inspection lot integration functionality.
  Check Configuration: Review the configuration settings related to inspection lot integration in both SAP ERP and SAP APO. Ensure that all necessary settings are correctly configured.
  Data Consistency: Ensure that the data being transferred between SAP ERP and SAP APO is consistent and correctly formatted. Check for any discrepancies that might cause integration issues.
  Consult Documentation: Refer to the SAP documentation for your specific version of APO to understand the requirements and limitations regarding inspection lot integration.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may provide additional guidance or patches related to this error.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they have found.
  SAP Support: If the issue persists after attempting the above solutions, consider reaching out to SAP Support for further assistance.
  
  By addressing the version compatibility and ensuring proper configuration and data integrity, you should be able to resolve the XC300 error message.