Do you have any question about this error?
Stop googling SAP errors. Use our Free Essentials plan instead - no credit card needed. Start Now →
Message type: E = Error
Message class: WRF_MPA - Messages for Markdown Profile Assignment
Message number: 010
Message text: Incorrect function code (&1) for change to phase 3
The system issues an error message and will not allow you to continue with this transaction until the error is resolved.
This is a system error. Please contact your system administrator.Error message extract from SAP system. Copyright SAP SE.
WRF_MPA010
- Incorrect function code (&1) for change to phase 3 ?The SAP error message WRF_MPA010 indicates that there is an issue with the function code being used in the context of a change to phase 3 of a material's lifecycle in the Material Planning (MP) module. This error typically arises when there is an attempt to perform an operation that is not allowed or is incorrectly coded for the current phase of the material.
Cause:
- Incorrect Function Code: The function code being used does not correspond to the expected operations allowed in phase 3 of the material lifecycle.
- Phase Restrictions: Certain operations may be restricted in phase 3, and the function code being used may not be valid for this phase.
- Configuration Issues: There may be configuration settings in the system that are not aligned with the expected behavior for phase transitions.
- Data Integrity Issues: There could be issues with the data integrity of the material master or related records that prevent the operation from being executed.
Solution:
- Check Function Code: Verify the function code being used and ensure it is appropriate for the operation you are trying to perform in phase 3. Refer to the SAP documentation for valid function codes in this context.
- Review Phase Transition Rules: Understand the rules and restrictions associated with phase 3 of the material lifecycle. Ensure that the operation you are attempting is allowed in this phase.
- Configuration Review: Check the configuration settings in the Material Management (MM) or Material Planning (MP) modules to ensure they are set up correctly for phase transitions.
- Data Validation: Validate the data in the material master and related records to ensure there are no inconsistencies or errors that could be causing the issue.
- Consult SAP Notes: Look for any relevant SAP Notes or documentation that may address this specific error message or provide guidance on resolving it.
- Contact SAP Support: If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
Related Information:
By following these steps, you should be able to identify the cause of the error and implement a suitable solution.
Get instant SAP help. Sign up for our Free Essentials Plan.
WRF_MPA009
You are not authorized to assign profiles
Diagnosis You are not authorized to assign markdown profiles to materials that do not have them yet. You are only authorized to display profile assig...
WRF_MPA008
You are not authorized to delete profile assignments
Diagnosis You are not authorized to delete existing profile assignments. You are only authorized to display profile assignments, change existing prof...
WRF_MPA011
Restrict the material selection
Diagnosis You entered "*" as selection criterion for the material number. The wildcard is not supported here. System Response The system is...
WRF_MPA012
You selection may exceed the permitted maximum of &1 records
Diagnosis You specified a maximum value for selecting data records in Customizing for markdown profile assignment. This maximum value was exceeded. T...
Click on this link to search all SAP messages.