How To Fix WC102 - No set com. maintained for material &

SAP Error Message - Details

• Message type: E = Error

• Message class: WC - POS interface - outbound and Tickets & Additionals

• Message number: 102

• Message text: No set com. maintained for material &

What causes this issue?

This error only occurs when no items were entered when a set was
created or when all items for a set were deleted without the header for
the bill of materials being deleted. Neither of these situations has a
use.

System Response

The record in question cannot be prepared for POS outbound.

How to fix this error?

If the set material was created without any items, these must be
maintained.
If you wish to delete the set in the POS, you have two options:
1. The bill of materials for the set can be deleted using
<DS:TRAN.CS02>Bill of material maintenance</> (use = 3,
alternative = 1).
At the next periodic transmission the set will then be deleted from
the POS.
2. The set can be deleted from the POS via
<DS:TRAN.WPMA>Direct deletion request</>.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message WC102 - No set com. maintained for material & ?

  The SAP error message WC102: No set com. maintained for material & typically occurs in the context of production planning or when working with work centers and routing in SAP. This error indicates that there is no set combination maintained for the specified material in the system. Here’s a breakdown of the cause, potential solutions, and related information:
  
  Cause:
  
  
  Missing Set Combination: The error arises when the system cannot find a valid set combination for the material in question. This could be due to:
  
  The material not being assigned to a specific set combination in the work center.
  The set combination not being defined in the configuration for the production process.
  
  
  
  
  Configuration Issues: There may be issues with the configuration settings in the work center or routing that prevent the system from recognizing the material.
  
  
  Data Inconsistencies: There could be inconsistencies in the master data related to the material or work center.
  
  
  
  Solution:
  
  
  Check Set Combinations:
  
  Go to the