How To Fix VSCE468 - Characteristic &1 uses external value checks

SAP Error Message - Details

• Message type: E = Error

• Message class: VSCE - Messages for SCE

• Message number: 468

• Message text: Characteristic &1 uses external value checks

What causes this issue?

The IPC does not support the function 'external value checks' via an
ABAP function module.

System Response

The characteristic is copied into the knowledge base without the ABAP
check function.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message VSCE468 - Characteristic &1 uses external value checks ?

  The SAP error message VSCE468 indicates that a characteristic in your configuration is using external value checks, which means that the characteristic is linked to a value that is validated against an external source. This can occur in scenarios where characteristics are defined in a way that they must adhere to specific values that are not directly defined within the SAP system but are instead checked against an external database or system.
  Cause:
  
  External Value Check Configuration: The characteristic is set up to use an external value check, which means it is expecting values from an external source.
  Missing or Incorrect External Source: The external source that the characteristic is supposed to validate against may not be correctly configured or may not be accessible.
  Data Inconsistency: The values being used may not match the expected values defined in the external source.
  
  Solution:
  
  Check Configuration: Verify the configuration of the characteristic in the SAP system. Ensure that the external value check is set up correctly and that the external source is properly defined.
  Validate External Source: Ensure that the external source (like a database or a service) is accessible and that it contains the expected values for the characteristic.
  Review Characteristic Values: Check the values being assigned to the characteristic in your configuration. Make sure they are valid according to the external value check.
  Adjust Value Assignment: If necessary, adjust the values being assigned to the characteristic to ensure they comply with the external value check requirements.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on configuring external value checks for characteristics.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CT04 (to maintain characteristics) or CU01 (to create/change configuration profiles) to review and adjust the settings.
  SAP Notes: Check for any relevant SAP Notes that may address known issues or provide additional guidance on handling external value checks.
  Support: If the issue persists, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  By following these steps, you should be able to identify the cause of the VSCE468 error and implement a solution to resolve it.