How To Fix USMD2080 - UI configuration &1 cannot be used

SAP Error Message - Details

• Message type: E = Error

• Message class: USMD2 - Master Data: UI Modeling

• Message number: 080

• Message text: UI configuration &1 cannot be used

What causes this issue?

You want to create an individual change request that is based on UI
configuration &V1&. (This UI configuration is either assigned to your
role or user parameters, or to the change request type with which you
want to create the request.) However, the UI configuration contains
subviews and therefore cannot be used.
Note
If you are creating the change request as the first step in processing
an entity (Web Dynpro application USMD_ENTITY_VALUE2), for example when
creating a supplier, the UI configuration used can contain subviews. The
restriction described above applies only to direct creation of
individual change requests with Web Dynpro application
USMD_CREQUEST_CREATE.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Make sure that you use a UI configuration that does not contain
subviews.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message USMD2080 - UI configuration &1 cannot be used ?

  The SAP error message USMD2080 indicates that a specific UI configuration cannot be used. This error typically arises in the context of SAP Master Data Governance (MDG) when there is an issue with the configuration of the user interface (UI) for a specific application or process.
  Cause:
  The error can be caused by several factors, including:
  
  Missing or Incomplete Configuration: The UI configuration might not be fully set up or is missing required components.
  Incorrect Assignment: The UI configuration may not be correctly assigned to the relevant business process or entity type.
  Authorization Issues: The user may not have the necessary authorizations to access the UI configuration.
  Technical Issues: There could be underlying technical issues, such as problems with the transport of the configuration or inconsistencies in the system.
  
  Solution:
  To resolve the USMD2080 error, you can take the following steps:
  
  
  Check Configuration:
  
  Go to the SAP MDG configuration settings and verify that the UI configuration is correctly set up.
  Ensure that all necessary components and settings are in place.
  
  
  
  Review Assignments:
  
  Check if the UI configuration is correctly assigned to the relevant business process or entity type.
  Make sure that the configuration is active and not in a draft or inactive state.
  
  
  
  Authorization Check:
  
  Verify that the user encountering the error has the necessary authorizations to access the UI configuration.
  Check the roles and authorizations assigned to the user in the SAP system.
  
  
  
  Technical Troubleshooting:
  
  If the issue persists, check for any transport issues or inconsistencies in the system.
  Review system logs for any additional error messages that might provide more context.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific UI configuration you are working with for any known issues or additional troubleshooting steps.
  
  
  
  Contact SAP Support:
  
  If you are unable to resolve the issue, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional guidance.
  MDG Configuration Guides: Review the official SAP MDG configuration guides for best practices and detailed instructions on setting up UI configurations.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify the cause of the USMD2080 error and implement a solution to resolve it.