How To Fix UPX128 - Compilation &1 to &2 cannot be executed; &3 is 0 in t006

SAP Error Message - Details

• Message type: E = Error

• Message class: UPX - UPX: Sales Planning for CRM

• Message number: 128

• Message text: Compilation &1 to &2 cannot be executed; &3 is 0 in t006

What causes this issue?

Table t006 contains inconsistent entries.

System Response

The conversion was not performed .

How to fix this error?

Check table t006 and correct the inconsistent entries.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UPX128 - Compilation &1 to &2 cannot be executed; &3 is 0 in t006 ?

  The SAP error message UPX128 indicates that there is an issue with the compilation of a certain object, specifically related to the data in table T006, which contains unit of measure information. The error message format suggests that the compilation process cannot be executed because a certain condition (in this case, &3 being 0) is not met.
  Cause:
  The error typically arises due to one of the following reasons:
  
  Missing or Inactive Units of Measure: The unit of measure that is being referenced in the compilation process may not exist or may be inactive in the T006 table.
  Data Inconsistency: There may be inconsistencies or missing entries in the T006 table that prevent the compilation from proceeding.
  Configuration Issues: There could be configuration issues related to the units of measure in the system.
  
  Solution:
  To resolve the UPX128 error, you can take the following steps:
  
  
  Check T006 Table:
  
  Use transaction SE11 or SE16 to view the T006 table.
  Verify that the units of measure referenced in the error message exist and are active.
  If any units of measure are missing, you may need to create them or activate them.
  
  
  
  Review Related Customizing Settings:
  
  Check the customizing settings for units of measure in the SAP system. This can be done through transaction SPRO.
  Navigate to the relevant sections for units of measure and ensure that all necessary configurations are correctly set up.
  
  
  
  Check for Data Consistency:
  
  Run consistency checks or reports that can help identify any inconsistencies in the data related to units of measure.
  If inconsistencies are found, correct them as necessary.
  
  
  
  Recompile the Object:
  
  After addressing any issues found in the T006 table or related configurations, attempt to recompile the object that was causing the error.
  
  
  
  Consult SAP Notes:
  
  Check the SAP Support Portal for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  
  
  Contact SAP Support:
  
  If the issue persists after following the above steps, consider reaching out to SAP Support for further assistance.
  
  
  
  Related Information:
  
  T006 Table: This table contains the definitions of units of measure in the SAP system. Each entry includes the unit of measure, its description, and its status (active/inactive).
  Transaction Codes: 
  
  SE11: Data Dictionary
  SE16: Data Browser
  SPRO: Customizing Implementation Guide
  
  
  SAP Notes: Always check for relevant SAP Notes that may provide fixes or additional information regarding specific error messages.
  
  By following these steps, you should be able to identify and resolve the issue causing the UPX128 error in your SAP system.