How To Fix UCS0060 - Assign the consolidation frequency to task &1

SAP Error Message - Details

• Message type: E = Error

• Message class: UCS0 - Messages for Status Management

• Message number: 060

• Message text: Assign the consolidation frequency to task &1

What causes this issue?

A consolidation frequency needs to be assigned (either explicitly or
implicitly) to each task used in the monitor. This is because the
display of tasks in the current period is dependent on the consolidation
frequency of that task.
This condition has not been met for task &V1& for one of the following
reasons:
RESET N1
A valid consolidation frequency has not been assigned to the current
combination of versions.
An invalid consolidation frequency has been explicitly assigned to task
&V1&.
Also note that the display of "balance carryforward" tasks in the
monitor is dependent on the consolidation frequency assigned to the
current version combination.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Make sure that a valid consolidation frequency is assigned to the
current combination of versions. If this is not the case, supply the
missing assignment.
Check the frequency assignment in the customizing settings for task &V1&
.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UCS0060 - Assign the consolidation frequency to task &1 ?

  The SAP error message UCS0060, which states "Assign the consolidation frequency to task &1," typically occurs in the context of SAP's Consolidation module, particularly when dealing with the configuration of consolidation tasks. This error indicates that a specific consolidation task has not been assigned a consolidation frequency, which is necessary for the system to know how often the consolidation process should occur.
  
  Cause:
  The primary cause of this error is that the consolidation task (identified by &1) has not been configured with a consolidation frequency. This can happen if:
  
  The task was created but not fully configured.
  The consolidation frequency was inadvertently removed or not set during the task setup.
  There may be a missing configuration in the consolidation settings.
  
  
  Solution:
  To resolve the UCS0060 error, you need to assign a consolidation frequency to the specified task. Here are the steps to do this:
  
  
  Access the Consolidation Task Configuration:
  
  Go to the SAP Easy Access screen.
  Navigate to the Consolidation