How To Fix UCF8015 - Selection range of task does not contain value &1 for characteristic &2

UCF8015 - Overview

• Message type: E = Error

• Message class: UCF8 - Messages for Manual Journal Entry

• Message number: 015

• Message text: Selection range of task does not contain value &1 for characteristic &2

What causes this issue?

You are executing the current task for a selection, which does not
include the value &V1& for characteristic &V2&.
This value cannot be posted.
Possible causes are as follows:
None of the currently valid hierarchies contain the value &V1&. (This
applies to characteristics with the roles "consolidation unit" and
"consolidation group".)
The value &V1& is not contained within the selection range being used
for the current task. The selection range is determined by one of the
following:
By the cursor position in the monitor when the task is run directly in
the monitor
By the selection screen of the task when the task is executed in the
selection screen

System Response

Task cannot be executed.

How to fix this error?

Replace value &V1& for characteristic &V2& with a valid value.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UCF8015 - Selection range of task does not contain value &1 for characteristic &2 ?

  The SAP error message UCF8015, which states "Selection range of task does not contain value &1 for characteristic &2," typically occurs in the context of SAP's Unified Change and Transport System (UCTS) or when working with characteristics in the context of tasks or transport requests. This error indicates that the value you are trying to use for a specific characteristic is not included in the selection range defined for that task.
  
  Cause:
  
  Missing Value in Selection Range: The value you are trying to use for the characteristic is not part of the defined selection range for the task. This can happen if the task was created with a specific set of values and the value you are trying to use was not included.
  Incorrect Configuration: There may be a misconfiguration in the task or characteristic settings that prevents the value from being recognized.
  Data Consistency Issues: There might be inconsistencies in the data or