How To Fix UCF7039 - InfoObject &1 not contained in InfoObject catalog of source data basis &2

UCF7039 - Overview

• Message type: E = Error

• Message class: UCF7 - Messages for Flexible Upload

• Message number: 039

• Message text: InfoObject &1 not contained in InfoObject catalog of source data basis &2

What causes this issue?

One of the following problems has occurred:
Case 1: Source data basis &V2& does not have an InfoObject catalog for
the defined characteristics.
Case 2: An InfoObject catalog is defined for source data basis &V2&, but
it does not contain InfoObject &V1&, which was specified on the entry
screen in Customizing.
Case 3: The name of InfoObject &V1& (which was specified on the entry
screen in Customizing) contains an error.

System Response

The customizing settings cannot be saved.

How to fix this error?

Proceed as follows depending on which case applies:
Case 1: Create an InfoObject catalog and make sure it contains the
desired InfoObject &V1&. Specify this InfoObject catalog in the
<ZK>InfoObject Catalog for Characteristics</> field in source data basis
&V2&. Save the source data basis &V2&.
Case 2: Add the desired InfoObject &V1& to the InfoObject catalog for
characteristics in source data basis &V2&. Save the source data basis
&V2&.
Case 3: Enter the correct InfoObject. Input help (F4) is also available.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message UCF7039 - InfoObject &1 not contained in InfoObject catalog of source data basis &2 ?

  The SAP error message UCF7039 indicates that a specific InfoObject (denoted as &1) is not found in the InfoObject catalog of the specified source data basis (denoted as &2). This error typically occurs during data extraction or transformation processes in SAP BW (Business Warehouse) or when working with InfoObjects in general.
  
  Cause:
  
  Missing InfoObject: The InfoObject you are trying to use does not exist in the specified InfoObject catalog. This could be due to it not being created, being deleted, or not being activated.
  Incorrect Source Data Basis: The source data basis you are referencing may not be correctly set up or may not include the InfoObject in question.
  Transport Issues: If the InfoObject was recently transported from another system, it may not have been properly imported or activated in the target system.
  Version Mismatch: There may be a version mismatch between the InfoObject in the source and the target system.
  
  
  Solution:
  
  Check InfoObject Existence: Verify that