How To Fix TD456 - Form & has incorrect page format

SAP Error Message - Details

• Message type: E = Error

• Message class: TD - SAPscript: Text editor, composer, forms, styles and fonts

• Message number: 456

• Message text: Form & has incorrect page format

What causes this issue?

Form &V1& was activated with START_FORM and has a different page format
to the forms previously activated.

System Response

Form &V1& will not be processed.

How to fix this error?

Page format cannot be changed while a form is been formatted. You begin
the formatting process with OPEN_FORM and end it with CLOSE_FORM. Forms
that are chained in this formatting process using START_FORM and
END_FORM must all have the same page format.
The page format first used, in this case the paper size &V2&, carries
over to all subsequent forms.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message TD456 - Form & has incorrect page format ?

  The SAP error message TD456, which states that "Form & has incorrect page format," typically occurs when there is a mismatch between the page format defined in the SAPscript or Smart Forms and the actual printer settings or the output device configuration. This can lead to issues when trying to print documents, as the system cannot properly format the output for the specified page size.
  Causes:
  
  Mismatch in Page Format: The page format defined in the form (SAPscript or Smart Forms) does not match the page format settings of the output device.
  Incorrect Output Device Configuration: The output device may not be configured correctly in SAP, leading to discrepancies in expected page formats.
  Form Changes: If the form was modified (e.g., changes in layout or page size) without updating the corresponding output device settings, this error can occur.
  Missing or Incorrect Page Format Definition: The page format may not be defined in the system or may be incorrectly set up.
  
  Solutions:
  
  
  Check Page Format in Form:
  
  Open the SAPscript or Smart Form in transaction SE71 (for SAPscript) or SMARTFORMS (for Smart Forms).
  Verify the page format settings and ensure they are correct.
  
  
  
  Verify Output Device Settings:
  
  Go to transaction SPAD (Spool Administration).
  Check the configuration of the output device being used. Ensure that the page format matches the one defined in the form.
  If necessary, adjust the output device settings to match the form's page format.
  
  
  
  Adjust Printer Settings:
  
  Ensure that the physical printer settings (if applicable) are set to the correct page size and format.
  Check if the printer supports the page format defined in the SAP form.
  
  
  
  Test with Different Output Device:
  
  If possible, try using a different output device that is known to work with the specified page format to see if the issue persists.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or notes related to the specific form and output device for any known issues or additional configuration steps.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  SE71: SAPscript Form Maintenance
  SMARTFORMS: Smart Forms Maintenance
  SPAD: Spool Administration
  
  
  Common Page Formats: A4, Letter, etc. Ensure that the form and output device are using the same standard page formats.
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to the TD456 error.
  
  By following these steps, you should be able to identify and resolve the cause of the TD456 error in SAP.