How To Fix TD241 - Conversion of &1 &2 into the measurement unit "&3" not possible

SAP Error Message - Details

• Message type: E = Error

• Message class: TD - SAPscript: Text editor, composer, forms, styles and fonts

• Message number: 241

• Message text: Conversion of &1 &2 into the measurement unit "&3" not possible

What causes this issue?

The CPI values (characters per inch) and LPI values (lines per inch)
are not unknown in on of the styles. For this reason values with the
units of measure "CH" ans "LN" cannot be converted into other units of
measure.

System Response

Initial value and unit remain unchanged.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message TD241 - Conversion of &1 &2 into the measurement unit "&3" not possible ?

  The SAP error message TD241 indicates that there is an issue with converting a quantity from one measurement unit to another. This typically occurs in scenarios where unit conversions are required, such as in inventory management, production planning, or sales and distribution processes.
  Cause:
  The error message TD241 can be triggered by several factors, including:
  
  Missing Conversion Factors: The conversion factors between the source unit and the target unit may not be defined in the system.
  Incorrect Unit of Measure: The units of measure being used may not be compatible or may not exist in the system.
  Data Entry Errors: There may be a typo or incorrect entry in the quantity or unit of measure fields.
  Configuration Issues: The configuration settings for units of measure in the SAP system may not be set up correctly.
  
  Solution:
  To resolve the TD241 error, you can take the following steps:
  
  
  Check Unit of Measure Configuration:
  
  Go to the transaction code CUNI (Unit of Measure Conversion) to check if the conversion factors between the units are defined.
  Ensure that both the source and target units of measure are correctly configured in the system.
  
  
  
  Verify Data Entry:
  
  Double-check the quantity and unit of measure entered in the transaction. Ensure that they are correct and valid.
  
  
  
  Review Material Master Data:
  
  If the error occurs in relation to a specific material, check the material master data (transaction code MM03) to ensure that the units of measure are correctly defined.
  
  
  
  Check for Custom Code:
  
  If there is any custom code or user exits that manipulate unit conversions, review that code to ensure it is functioning correctly.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help resources for any specific notes related to the error message TD241.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: 
  
  CUNI - Unit of Measure Conversion
  MM03 - Display Material Master
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  Unit of Measure Types: Familiarize yourself with the different types of units of measure (e.g., base unit, alternative unit) and their configurations in SAP.
  
  By following these steps, you should be able to identify and resolve the cause of the TD241 error in your SAP system.