How To Fix SY407 - You cannot set more than & breakpoints

SY407 - Overview

• Message type: E = Error

• Message class: SY - ABAP/4 system messages

• Message number: 407

• Message text: You cannot set more than & breakpoints

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message SY407 - You cannot set more than & breakpoints ?

  The SAP error message SY407 indicates that you have exceeded the maximum number of breakpoints that can be set in the ABAP debugger. This limit is typically set to prevent performance issues and to manage resources effectively within the SAP system.
  
  Cause:
  The error occurs when you attempt to set more breakpoints than the system allows. The maximum number of breakpoints can vary depending on the system configuration, but it is generally limited to a certain number (often around 20 or 30).
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Remove Unused Breakpoints: 
  
  Open the ABAP debugger.
  Go to the "Breakpoints" tab or use the command /h to enter the debugger.
  Review the list of breakpoints that you have set.
  Remove any breakpoints that are no longer needed by selecting them and deleting them.
  
  
  
  Check for System Limits:
  
  If you frequently hit this limit, consider checking with your SAP Basis team to see if the limit can