How To Fix SWRD210 - The condition in node & cannot be exported

SAP Error Message - Details

• Message type: E = Error

• Message class: SWRD - Business Workflow: WAPI Interfaces of Definition

• Message number: 210

• Message text: The condition in node & cannot be exported

What causes this issue?

The output format does not provide any conditions for this node type.

System Response

The condition is not exported. The information is lost.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message SWRD210 - The condition in node & cannot be exported ?

  The SAP error message SWRD210, which states "The condition in node & cannot be exported," typically occurs in the context of SAP Workflow or Business Process Management (BPM) when there is an issue with the workflow definition or the conditions set within a workflow node.
  Cause:
  
  Invalid Condition Logic: The condition defined in the specified node may be invalid or not properly configured. This could be due to syntax errors or logical errors in the condition expression.
  Missing Dependencies: The node may depend on certain variables or data that are not available or not correctly defined in the workflow context.
  Inconsistent Workflow Configuration: There may be inconsistencies in the workflow configuration, such as missing or incorrectly linked nodes.
  Transport Issues: If the workflow was transported from one system to another, there may be issues with the transport that affect the conditions in the workflow.
  
  Solution:
  
  Check Condition Logic: Review the condition defined in the node. Ensure that the syntax is correct and that the logic is valid. You can do this by editing the workflow and checking the condition settings.
  Verify Variables: Ensure that all variables used in the condition are correctly defined and available in the workflow context. Check if any required data is missing.
  Review Workflow Configuration: Go through the entire workflow configuration to ensure that all nodes are correctly linked and that there are no inconsistencies.
  Test the Workflow: After making changes, test the workflow to see if the error persists. Use the workflow log to identify any further issues.
  Transport Check: If the workflow was transported, check the transport logs for any errors or warnings. You may need to re-transport the workflow or manually adjust the conditions in the target system.
  
  Related Information:
  
  SAP Notes: Check SAP Notes related to SWRD210 for any specific patches or updates that may address this issue.
  Workflow Documentation: Refer to SAP documentation on workflow configuration and troubleshooting for more detailed guidance.
  Community Forums: Engage with SAP community forums or support channels where similar issues may have been discussed.
  
  If the problem persists after trying the above solutions, consider reaching out to SAP support for further assistance.