How To Fix RMXTTLS103 - Units of characteristic &1 and nutrient &2 have different dimensions

RMXTTLS103 - Overview

• Message type: E = Error

• Message class: RMXTTLS - TMS-TLS: Messages for Trial Interface and Tool Package

• Message number: 103

• Message text: Units of characteristic &1 and nutrient &2 have different dimensions

What causes this issue?

When you assign a nutrient to a characteristic, the unit of the
characteristic and the unit of the nutrient have to belong to the same
dimension.
Example:
Unit of characteristic = mg, unit of nutrient = g ->
permitted, since both
units belong to the <zk>Mass</> dimension.
Unit of characteristic = ml, unit of nutrient = g -> not permitted,
since the units belong to different dimensions.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

Check the unit of the characteristic and of the nutrient and adjust them
if necessary.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

RMXTTLS103 - Details

• The SAP error message RMXTTLS103 indicates that there is a mismatch in the units of measurement for a characteristic and a nutrient in the context of a recipe or a product specification. This typically occurs in the SAP Environment, Health, and Safety (EHS) or Product Lifecycle Management (PLM) modules, particularly when dealing with recipes, specifications, or material master data.
  
  Cause:
  The error arises when:
  
  The unit of measurement (UoM) for a characteristic (e.g., a property of a material) does not match the unit of measurement for a nutrient (e.g., a component of a recipe).
  The dimensions of the units are incompatible, such as comparing mass (grams) with volume (liters) without a proper conversion or context.
  There may be a configuration issue in the material master or recipe setup where the units are not aligned.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Units of Measurement:
  
  Go to the material master or recipe where the