How To Fix REBDMS011 - More than 1 measurement type is assigned to basic component grouping &1

REBDMS011 - Overview

• Message type: E = Error

• Message class: REBDMS - Messages for Measurements

• Message number: 011

• Message text: More than 1 measurement type is assigned to basic component grouping &1

What causes this issue?

Several measurement types were assigned to basic component grouping
&v1&. Therefore, the system can no longer determine the basic
components for the M/L master data.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message REBDMS011 - More than 1 measurement type is assigned to basic component grouping &1 ?

  The SAP error message REBDMS011 indicates that there is an issue with the configuration of measurement types assigned to a basic component grouping in the SAP system. Specifically, it means that more than one measurement type has been assigned to a single basic component grouping, which is not allowed.
  
  Cause:
  The primary cause of this error is that the basic component grouping (identified by &1 in the error message) has multiple measurement types assigned to it. In SAP, each basic component grouping should only have one measurement type to ensure proper data handling and reporting.
  
  Solution:
  To resolve this error, you need to check the configuration of the basic component grouping and ensure that only one measurement type is assigned. Here are the steps to do this:
  
  
  Access the Configuration:
  
  Go to the relevant transaction in SAP (usually in the area of configuration for basic components or measurement types).
  You may use transaction codes like SPRO to